Skip to content
Free Shipping on All US Orders over $250 - Use Code "ECONOMYSHIPPING" at Check Out
Free Shipping on All US Orders over $250 - Use Code "ECONOMYSHIPPING" at Check Out

BLDC ESC 4.12 Compatible with VESC® Tool*

$99.99

 

 Now Ships with Pre-Soldered XT60 Connector.

The BLDC ESC 4.12 is based upon the VESC® Open Source Project, and compatible with VESC® Software.

The BLDC ESC 4.12 is a highly modifiable electronic speed controller designed for DIY Electric Skateboards conversions in mind.

The BLDC ESC 4.12 allows you to use sensorless motors to achieve smooth start-up from a stop, while traditional RC ESC's may have trouble starting. It also provides strong reliable and progressive electric braking.

Comes with pre-soldered 4mm bullet connectors. (Compatible with all MBoards Motors). 

Capable of BLDC and FOC mode. 

Customizable settings with VESC® Tool. 

Specs:

◆ Hardware:V4.12
◆ Firmware: V3.38
◆ PCB:4 layers, size: 40*60mm
◆ Current: 50A continuous / 240A peak
◆ Voltage: 8V-60V (Cells: 3-13S LiPo)
◆ BEC: 5V@1.5A
◆ BEC type: Internal driver support 
◆ Timing: Software calibration 
◆ Motor control interface: PPM signal (RC servo), analog, UART, I2C, 
  USB or CAN‐bus. 
◆ Cutoff Voltage: Programmable
◆ Frequency: PWM input 
◆ Governor: No
◆ Weight: 80g
◆ BLDC ESC 4.12 Size: 60x40x20mm
◆ Programming card: No
◆ Reverse: Yes

What's In the Box? 

(1) BLDC ESC 4.12
(1) Mini USB 
(1) PPM cable soldered on board

 

*VESC is a registered trademark owned by Benjamin Vedder.
VESC Hardware by Benjamin Vedder is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

For more Information and to download the PC software please visit (http://vedder.se/2015/01/vesc-open-source-es-c/) .